Synergy JK OE Replacement Drive Shaft Instrukcja Użytkownika Pobierz pdf

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397

JK DRIVE SHAFT INSTALLATION INSTRUCTIONS

Version 1.1

GENERAL NOTES:

• These instruction are for the installation of 1310 and 1350 JK drive shafts, any

differences will be noted

• Front and rear procedures are the same, any differences will be noted.

• Pinion yoke torque is very critical, follow the instructions completely or you may

over crush the crush sleeve and have to completely disassemble the differential to

replace it.

• We recommend that you install a new pinion nut when replacing the pinion yoke.

New nuts are available from the dealer at a reasonable price.

• Front pinion nut: 04720895

• Rear pinion nut: 05191197AA

PINION YOKE

1. Support the axle on jack stands and remove the tires and wheels

2. Remove the factory drive shafts.

3. Using a flat head screwdriver wedged between the inner brake pad and caliper piston,

push the brake caliper piston in slightly. Slide the caliper outward so the brake pads

do not touch the rotors as to relieve any drag between the brake pads and rotors.

1 2 3

Strona 1

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397 JK DRIVE SHAFT INSTALLATION INSTRUCTIONS Version 1.1 GENERAL NOTES: • Th

4. Rotate the pinion gear three or four times and record pinion torque to rotate with an inch pound torque wrench. 5. Remove the T-case yoke

9. Remove the T-case yoke nut and yoke. A puller is normally needed to remove the yoke from the output shaft. 10. The new yokes may come with or w

Brak uwag

Synergy JK OE Replacement Drive Shaft Instrukcja Użytkownika